14.1 – Percentage Risk

Last chapter we looked at three important position sizing techniques, all of them were unique in their own merit. The three techniques were –

  • Unit per fixed amount
  • Percentage Margin
  • Percentage Volatility

All three methods work differently and when combined with a certain equity estimation technique, they produce totally different results. Given this, it is really up to you to figure out the marriage of which position sizing technique with which equity estimation technique works best for you.

Before I proceed, I thought it is important to discuss another practical position sizing technique, called the ‘Percentage Risk’, method. I do know quite a few traders who use this and I myself find this quite simple and intuitive technique to use.

The percentage risk method, relies upon your own assessment of ‘loss’ that you are willing to bear for a given trade. This, as you may know is also called the ‘Stop loss’ for the trade. The stop loss for a trade is the price at which you decide to close the trade and take a hit. The percentage risk technique controls the position size as a function of risk defined by stop loss.

Let me take the example of a stock futures and explain how this works, in fact, I think this is a good trade setup  –

Here is an intraday chart of Tata Motors, the frequency is 15 mins (14th Sept 2017, around 11:30 AM).

Let me explain why this is a trade worth considering –

Tata Motors is at 393.65, which happens to be a price action zone, considering it tested the same level, twice in the past. So this makes 393.65, a support price for Tata Motors (on an intraday basis). Both the times in the past, the price declined of Tata Motors declined when the stock tested 393.65. Given this, there is a possibility that the price could again test 393.65 and react to bounce back to the price from which it started to decline i.e 400.

Also, do notice the low volume retracement between 400 to 393.65 – I’ve discussed why I like trades like these in the Technical Analysis module. If you’ve not read that module, maybe you should ☺

Considering these factors, a trader could be inclined to go long on Tata Motors Futures at 393.65.

What if the trade heads the other direction? What is the stop loss?

I notice some sort of support at 390/-, hence I’d be happy to set this as stop loss for the trade.

Nothing complicated, as you can see this is a very straightforward setup.

So the trade would be –

Stock: Tata Motors Limited

Trade: Long

Trade Price: 393.65

Target Price: At least 400

Target value 6.35

Stop loss Price: 390

Stop loss value: 3.65

Reward to Risk: 1.7 (which is great for an intraday trade)

Lot size: 1500

Margin Required: 73.5K

Now assume I have a capital of Rs.500,000/-, how many lots of Tata Motors can I buy considering the margin per lot is Rs.73,500/-?

Technically speaking one can buy up to 6.8 or 6 lots –

500000/73500

=6.8

However the question is – would you expose your entire capital to this one trade alone? Not a smart thing to do, if you were to ask me, because if the trade goes wrong, you would be losing Rs.32,850/- (3.65 * 1500 * 6) on this trade.

In other words, you would lose –

32850/500000

=6.57% of your capital on one trade.

However great a trade set up is, it is not a smart thing to expose so much capital to risk. As a thumb rule, professional traders do not risk more than 1 to 3% of their capital on any single trade, and this rule forms the core of the ‘Percentage risk’ position sizing technique.

Given this, let us define the maximum risk per trade as a percentage of overall capital – maybe 1.5% for now. This means on this trade, the maximum loss I’m willing to bear is

1.5% * 500000

Rs.7,500/-

In other words, I don’t intend to lose more than Rs.7,500/- on any single trade. This is the maximum loss threshold.

We know the stop loss for this trade is 390, from an entry price of 393.65, the stop loss in absolute Rupee terms is –

393.65 – 390

= 3.65

The loss per lot is –

3.65 * 1500

= 5475

In the event the stop loss is triggered I would be taking a hit of Rs.5475 per lot.

Now to identify the number of lots I could take for the risk I’m willing to bear, I simply have to divide the maximum threshold by the loss per trade.

= 7500/5475

= 1.36

Therefore, on this trade I can go ahead and buy up to 1 lot, which will cost me Rs.73,500/- as margin deposits.

For the next trade, it is prudent (or rather conservative in a positive way) to reduce the money blocked from the overall capital and re-work the maximum loss threshold. Let’s do that and identify the new max loss threshold –

500000 – 73500

= 426,500

1.5% * 426500

= 6397.5

Given this, for the next trade, I will work out the stop loss, multiply that with the lot size and divide the max risk i.e 6397.5 by loss threshold to identify how many lots I can transact in.

So on and so forth!

By the way, curious to know how the trade panned out? Here you go –

I like trades like these, when the price does not even approach close to the stop loss J. As I had pointed out earlier, I did have a great amount of conviction on this trade. This leads me to the next topic – how do I position size when my conviction on a particular trade is high? What in such situations I want to expose a slightly higher capital?

Well, say hello to Kelly’s Criterion!

14.2 – Kelly’s Criterion

Kelly’ Criterion has an interesting background. It was proposed by John Kelly in the 50’s who at that point was working for AT&T’s Bell Laboratories. He in fact, suggested the Kelly’s Criterion to help the telecom company with long distance telephone noise issues. However, the same theory was adopted by professional gamblers to identify the optimal bet size. This soon found its way to the stock markets as well, and there are many professional traders and investors who use Kelly’s Criterion for bet sizing. Perhaps, this is one of those very few tools that both traders and investors commonly use.

I still don’t know how the transition from Telecom to stock markets happened – I’m a Telecom Engineer by qualification (although I know nothing about Telecommunications now) and I’ve been involved in Stock markets for over 13+ years….but I just can’t wrap my head around how Kelly’s Criterion made its transition across these two different worlds J

Anyway, the Kelly’s Criterion essentially helps us estimate the optimal bet size (or the fraction of our trading capital) considering –

  • We have a certain information on the bet we are about to take
  • We have an edge taking that particular bet

Let’s jump straight to Kelly’s Criterion with an example. The Kelly’s Criterion is an equation, the output of which is a percentage, also known as a the Kelly’s percent. The equation is as below –

Kelly % = W – [(1-W)/R]

Where,

W = Winning probability

R = Win/Loss ratio.

  • The winning probability is defined as the total number of winning trades divided over the total number of trades
  • The win/loss ratio is the average gain of winning trades divided over average loss of the negative trades.

To understand this better, let’s take up an example. Assume I have a trading system which has produced the following results, for sake of simplicity, let’s assume this is a trading system to trade just one stock, Tata Motors.

Sl No Signal Date Result P&L (in INR)
01 3rd Sept Win + 5,325
02 4th Sept Win +2,312
03 5th Sept Win +4,891
04 6th Sept Loss – 6,897
05 11th Sept Win +1,763
06 12th Sept Loss -3,231
07 13th Sept Loss -989
08 14th Sept Loss -1,980
09 15th Sept Win +8,675
10 18th Sept Win +4,231

Given the above data –

W = Total Number of winners / Total number of trades

= 6/10

=0.6

R = Average Gain / Average Loss

Average gain = Average of [5325, 2312, 4891, 1763, 8675, 4231]

= 4,532

Average loss = Average of [6897, 231, 989, 1980]

=3,274

R = 4532 / 3274

= 1.384

Do note, a number greater than 1 is always desirable as it indicates that your average gains are higher than your average loss.

Lets plug these numbers back to the Kelly’s Criterion equation –

Kelly % = W – [(1-W)/R]

= 0.6 – [(1-0.6)/1.384]

=0.6 – [0.4/1.384]

= 0.31 or 31%.

As per the original school of thought – Kelly’s percentage is a direct representation of how much capital one should expose for a trade. For example, for the 11th trade on Tata Motors, Kelly’s Criterion suggests a capital exposure of 31%.

But I think this can be a little tricky, imagine a trading system with great accuracy – the Kelly;s Percentage can turn out to be 70%, suggesting a capital exposure of 70% to the next trade. Not a very smart thing to do if you ask me. However, you may ask why not? After all a system with 70% accuracy is a great, so why not maximize the bet?

This is because, there is still a 30% chance to lose 70% of your capital!

Given this, here is a simple modification to Kelly’s criterion. Let us go back to the percentage risk position sizing technique we discussed earlier in the chapter.

We defined the percentage risk as a technique wherein the exposure to a trade is defined as 1.5% (or any percentage) of the capital. Given Kelly’s criterion, we can modify the exposure as ‘up to 5%’ (or any percentage you deem suitable).

What does this mean? This means for a given trade, I would not expose more than 5% of the capital. This also means that capital exposed could range from as low as 0.1% to all the way up to 5%. So how do I decide?

We can use Kelly’s percentage here. For example if the Kelly’s percentage is 30%, then I’d expose, 30% of 5% or in other words, I’d expose 1.5%. If the Kelly’s percentage is 70%, then I’d expose 70% of 5% or say 3.5% of the capital on the trade.

So higher the Kelly’s percentage, higher is the capital exposed and vice versa.

For a more Mathematical explanation on Kelly’s Criterion, I’d suggest you watch this video, if not for anything, watch from the 10th minute onward.

With this, I’d like to close the discussion on position sizing, hopefully the last 4 chapters has given you a fair understanding of the importance of position sizing and techniques to position size your bets.

Onwards to ‘Trading and Investing Biases’.


Key takeaways from this chapter

  1. Percentage Risk is an easy and intuitive position sizing technique
  2. One has to define the maximum amount of risk one as a percentage of capital, dividing this over the stop-loss gives us a sense of how much capital one should expose to a trade
  3. Kelly’s Criterion suggests how much capital one can expose for a given trade
  4. One can combine Kelly’s Criterion with percentage risk for optimal results



68 comments

View all comments →
  1. Umer Azam says:

    I must say Sir, varsity has become an addiction?
    Suppose, I have an innumerable no. Of trades, in that what no. Of past trades should i consider looking?

    Also if I am investing in a particular stock which I have not previously traded/invested, will Kelly’s criterion work?
    I mean to say is it independent of the past types of stocks i have traded?

    • Karthik Rangappa says:

      Learning is a good addition to have 🙂

      You are right – Kelly’s Criterion requires you to have a history of past trades. Does not work if you do not have a history. However, this reminds me – there is a technique to generalise this and make it independent of past trades. Will try and put this up.

  2. Sudheer says:

    Hi Karthik,
    How do we do such calculations in the live market.We cannot obviously di it beforehand nor in live markets as the price may go further in the time we do the calculation.How should we manage to do this?

    • Karthik Rangappa says:

      Well, all your trades have to be planned. These things are there to help you make that plan. Impulsive trades in markets often results in bad P&L.

  3. sharma says:

    Sir,
    A little bit off topic but please clarify me about gapup gapdown opening. Suppose today’s closing price of a stoct is 100 and in the last minute of trading session, I place a gtc buy order at 97 which is not executed on that day. If on the next day market directly opens at 94, will my order have been executed?

    • Karthik Rangappa says:

      No, for two reason –
      1) All pending orders are cancelled at the end of the day
      2) For a minute lets assume the orders are carried forward, even in this case the order will not really get executed as the price has gapped below your limit price.

  4. Ravi Kumar BA says:

    Sir, when implementing options strategy, usually I have seen both legs going in loss in the short term (first 1-3 days) and then turn to profits ( probably).. now should I square off oweing to my stoploss or should I wait for more time, which means could be deep loss or profit too??
    What do u do usually?

    • Karthik Rangappa says:

      Well, if this is a pattern which is working consistently, then may you should tweak it give you better entry signals. Of course, holding makes sense 🙂

  5. Chetan says:

    Hi Kartik,

    I would generally trade FnO and would love to know precise position sizing technique used in trading it.
    I generally take an intraday trade with fixed 2% SL from entry point. How should I calculate position size for such trades? Please help.

    Regards,
    Chetan

    • Karthik Rangappa says:

      I guess some of the techniques explained earlier in the modules – like total equity, reduced equity models helps. Have you looked at them?

View all comments →
Post a comment